4/6/2023 0 Comments Netsh trace wiresharkRun the following cmdlet: Get-NetTCPSetting | Set-NetTCPSetting -AutoTuningLevelLocal Normal Use PowerShell to enable the autotuning level To check if the autotuning level is enabled, use the following command: netsh int tcp show global Run the following command: netsh int tcp set global autotuninglevel=normal Use Command Prompt to enable the autotuning level Use Windows Command Prompt or Windows PowerShell to enable the option by setting the TCP receive window autotuning level. That's because the TCP Window Scale option isn't enabled on either server. The throughput measured with the ctsTraffic tool is lower than the baseline. Two servers located in different sites are connected over a high latency network. Slow throughput speed on a high latency and bandwidth network Slow throughput on low latency and high bandwidth network.Slow throughput on high latency and high bandwidth network.This article describes the following TCP/IP performance issues: You can review Part 1: TCP/IP performance overview and Part 2: TCP/IP performance underlying network issues. This article is included in a 3-part series.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |